740000795 – Cornelius UFB1/SFV1 High-Yield Purple Flow-Control Module

740000795 – Cornelius UFB1/SFV1 High-Yield Purple Flow-Control Module

The Cornelius 740000795 High-Yield Purple Flow-Control Module is an OEM replacement assembly used in compatible Cornelius UFB1 and SFV1 post-mix beverage dispensing valves.

Installed within the dispensing valve’s flow-control section, the module helps regulate beverage-component flow so the valve can dispense consistently at its intended setting. Stable flow is important for maintaining the required water-to-syrup relationship, beverage quality and repeatable serving performance.

The purple housing provides visual identification of this specific high-yield configuration. It should not be substituted with a differently coloured or differently calibrated flow-control module unless compatibility has been confirmed from the dispenser’s parts documentation.

Main Features:

• Genuine Cornelius replacement component
• Complete flow-control module/assembly
• High-yield configuration
• Distinctive purple housing for identification
• Designed for compatible UFB1 and SFV1 dispensing valves
• Helps maintain controlled beverage-component flow
• Supports consistent beverage dispensing
• Assists with correct beverage ratio adjustment
• Modular design facilitates valve servicing
• Suitable for commercial post-mix beverage dispensers
• Direct service replacement when matched by OEM part number

Technical Specifications:

The OEM part is commercially listed as “FLOW-CNTL ASY HIGHYIELD PURPLE.”

Product Function:

A post-mix dispensing valve combines carbonated or still water with beverage concentrate or syrup at the point of dispensing. The flow-control assembly helps manage the flow of the applicable beverage stream through the valve.

Correct operation helps support:

• Stable dispensing performance
• Consistent water and syrup proportions
• Repeatable beverage taste
• Controlled serving output
• Reduced over-concentration or under-concentration
• Easier beverage-ratio calibration

Cornelius UFB1 valves use replaceable flow-control components and are available in several flow configurations. The valve’s flow controller is therefore a serviceable part that must match the intended equipment setup.

Symptoms That May Indicate Replacement Is Required

Inspection or replacement may be needed if the dispenser shows:

• Inconsistent beverage flow
• Incorrect or unstable beverage ratio
• Beverage dispensing too weak or too concentrated
• Difficulty completing the required ratio adjustment
• Fluctuating flow during dispensing
• Leakage from the flow-control area
• Cracked, worn or damaged housing
• Internal sticking or contamination
• Failure to maintain calibration after adjustment

These symptoms can also result from supply-pressure problems, blocked tubing, worn seals, valve-head faults or incorrect syrup conditions. The complete dispensing system should therefore be diagnosed before replacing the module.

Compatibility:

Part 740000795 is associated with compatible:

• Cornelius UFB1 dispensing valves
• Cornelius SFV1 dispensing-valve configurations
• Beverage valves requiring the purple high-yield flow-control assembly